Up for sale is a 2014 International DuraStar 4300, 7.6L L6 DIESEL. This is a very nicely equipped service truck from Pike Electric. Truck has a very nice Adkins 11 ft bed that has a higher torch and welder cabinet as well as a sliding cover for the bed portion of truck. It has an Autocrane 3023 as well as a Vanair 40 compressor with 478hours. It also has a Bobcat 225 diesel welder with 312 hours. The bed has two sections with draw packs and it has the standard latches as well as locking rods on both sides. Replacement cost on the bed alone is over $76k, The truck itself has an air ride rear suspension with dump valve and a selectable rear locker. Very sweet specs. Truck has original white paint and truck is very clean. It has brand new virgin rubber all around, both seats are air ride and it has a deep console between the seats. It has led interior lights and some work lights/fog lights. Truck is over CDL. We bought it with a bad transmission. We had Overdrive Rebuilds in Concord NC rebuild the 6 speed transmission and we installed a new clutch when we put it back in. The truck has 290k miles, 8600 hrs , cold air, hot heat, runs out welll and turns around on a dime . It has a check engine light for an emission code but hasn’t effected its performance in any manner to date. The remote for the crane and compressor is in the rear box and is new and the correct one however we do not know how to work it🤷🏼‍♂️ and haven’t had time to drive to adkins for a tutorial. We replaced this truck with a 550 size truck that is 4wd. That’s why it’s for sale. Call 7045072453 for any further questions or to set up a time to view