2021 BFK X1 Six Shooter Concrete Reclaimer / 1 to 6 Truck Operation with 1/4 to 1/2 yard per minute.

Shroud Assembly:

1/4" plate and structural steel housing weldment, manufactured for right or left hand sand discharge.
Infeed hopper is 3' x 4' wide approx. 1/2 cubic yard capacity with adjustable slide gates over infeed auger to regulate feed rate into cylinder.
11 gauge bolt n covers for ease of access to to all internal assemblies and components.
Main pipe header is 3" with appropriate outlets to direct water flow to all critical locations for ease of cleaning materials.
Rotor nozzles equipped with removable plugs for ease of clean out.
8" dia. drain box.

Rotor Assembly:

Weldment/Assembly with infeed auger, screen section with a 2" dia. machined shafting mounted on single 4" pipe shaft.
Infeed auger is 8" dia. half pitch AR steel flighting.
Allows to controlled feed into the rotary screen as to minimize overfeeding.
21" dia. x 4' long Rotary screen has a 1/4" square opening with 14 gauge steel wire.
3 hp / 230 / 460v / 3PH direct drive gearmotor.
Front bushing assembly, machined UHMW bushing (eliminates bearing and seal issues)

Sand Screw Assembly:

12' dia. x 6' long auger with half pitch AR steel complete with 2" dia. machined shafting.
3 hp / 230 / 460 / 3 PH direct drive gearmotor.
Lower bushing assembly, machined UHMW (eliminates bearing and seal issues)

Control Panel:

230 / 460 VAC / 3 PH with manual on / off functions
Includes main disconnect. motor starter with fuses and integral wiring for reclaimer operation.

** Buyer Responsible for Removal**

***Location requires an appointment 48 hours in advance of pickup, unscheduled pickups will be turned away. A loadout ticket is required at the time of pickup***